![]() ![]() Yeah, installing in a conda environment on Ubuntu is currently pretty finicky (see #2836, #1979, and #2441). Unable to access Network Folders in GNOME “Unable to access location, TLS/SSL support not available” when trying to connect to webdav I saw this problem everywhere, not just psychopy When I google TLS/SSL support not available install glib-networking Now, I tried to install all version of webkitgtk I was able to go further, but I couldn’t do anything else at all. TLS/SSL support not available install glib-networking I always receive similar error messages, when I clicked online synching buttons that say I did everything as they mentioned, but I still can’t synch to However, there are still problems to synch Psychopy builder to Time: Debug: Adding duplicate image handler for ‘Windows bitmap file’ Gtk-Message: time: Failed to load module “canberra-gtk-module” Gtk-Message: time: Failed to load module “atk-bridge” ![]() Gtk-Message: time: Failed to load module “overlay-scrollbar” I can run a created experiment locally.Įven though I can still use Builder and Coder, there are still some wierd messages like below Now, I am able to use Psychopy Builder and Coder. Libwebkitgtk-1.0-0 is already the newest version (2.4.11-3ubuntu3).Īccording to below forum discussion, and I had same experienced, I uninstall Psychtoolbox. Note, selecting ‘libwebkitgtk-1.0-0’ for regex ‘libwebkitgtk-1.0’ Note, selecting ‘libwebkitgtk-1.0-common’ for regex ‘libwebkitgtk-1.0’ Now, when I type the above code again, it shows below feedback. I used the environment file, and I made sure to install webkitgtk by typing below. I installed psychopy following instructions of this link ![]() **PsychoPy version : 2020.1.2 conda installedīe able to synch a created project from Psychopy Builder to ![]()
0 Comments
Leave a Reply. |